Skip to content

4.9 from 601 Google reviews

Septic system installation in Dayton, TX

High-quality septic system installs backed by 125+ years of combined experience, planned around your lot and your household.

Two workers in hats kneel over green lids in an excavated trench in a yard

The right system starts with your dirt

No two lots take a septic system the same way. Before anything gets dug, the site is checked for soil type, how well it drains, how high the groundwater sits, the slope of the land, and the distance from wells, homes and property lines.

Then the system is sized for the household: how many bedrooms, how much water you use each day. Around Dayton, heavy clay and wet ground often point to an aerobic system with spray dispersal, and that’s where most of our installs start. We install Nayadic aerobic systems made by Consolidated Treatment Systems.

Want the full design story? See our septic design services.

Four steps from first call to first flush

  1. 1

    Consultation and planning

    We walk the property with you, talk through how your household uses water, and look at what the site will allow.

  2. 2

    Permit authorization

    The design goes in for approval, and nobody digs until the permit is in hand. Who issues it is covered in the FAQ.

  3. 3

    Scheduling and installation

    We set a date, bring the equipment, and put the system in the ground.

  4. 4

    Final inspection and commissioning

    The system is inspected and tested so the pump, floats, aerator, alarm and spray heads all do their jobs from day one.

Installation day

It’s a construction project, so expect heavy equipment, some noise and a torn-up patch of yard for a little while. Here’s what’s going on out there.

Keep vehicles off the area

Don’t drive over the installation until the soil has fully settled.

  1. 1

    Excavation

    The tank hole is dug and the trenches and spray area are prepared.

  2. 2

    Setting tanks and components

    Trash tank, treatment tank and pump tank are lowered in and leveled. An uneven tank throws off floats and pumps, so this matters.

  3. 3

    Plumbing

    Underground lines connect the house to the tanks and the tanks to the dispersal area.

  4. 4

    Electrical and control panel

    The control panel is mounted and wired to the pump, aerator and alarm.

  5. 5

    Dispersal area and final grading

    Spray heads are set and tested, lids are brought to the right height, and the yard is backfilled and leveled.

Commonly asked questions

How long does septic system installation take?

A typical residential installation usually takes 1 to 3 days once construction begins. The full process, including design, permits and inspections, can take 1 to 4 weeks or longer depending on the project.

My new aerobic system is in. Is maintenance included?

New aerobic systems in Texas come with an initial two-year service policy, starting when the system is first used. After that, a maintenance contract keeps the inspections on schedule.

How do I know if I need a new system rather than a repair?

Replacement usually comes up when the system backs up again and again, when the drain field has clearly failed, or when it no longer meets local rules. We’ll tell you honestly if a repair will do.

Permit questions? Read the FAQ on our Services page or our guide to what the installation process looks like.

Let’s Talk Soon

You’re only one call away from talking to someone who knows septic systems. Rather write it down? Send us a message and we’ll reach out to you.

(936) 258-3080

Monday–Friday, 8 AM–5 PM

Send us a message